Search results
15 sie 2024 · The ntp clock-period command automatically appears in the configuration when you enable NTP. The command is used in order to adjust the software clock. The 'adjustment value' compensates for the 4 msec tick interval, so that, with the minor adjustment, you have 1 second at the end of the interval.
- Mobi
C€ˆents Introduction ‚?‚:...
- ePub
ePub - Troubleshoot and Debug Network Time Protocol (NTP)...
- Troubleshoot Network Time Protocol
NTP servers are normally dedicated NTP devices that use a...
- NTP Clock-Period Not Being Configured
Note: The ntp clock-period command is added automatically to...
- Log In
Chętnie wyświetlilibyśmy opis, ale witryna, którą oglądasz,...
- Use Best Practices for Network Time Protocol
The NTP SNMP data is defined by the Cisco-NTP-MIB. For...
- Troubleshooting TechNotes
Troubleshoot and Debug Network Time Protocol (NTP) Issues ;...
- Mobi
19 sty 2021 · NTP runs on User Datagram Protocol (UDP), which in turn runs on IP. NTP Version 3 is documented in RFC 1305. An NTP network usually gets its time from an authoritative time source such as a radio clock or an atomic clock attached to a time server. NTP then distributes this time across the network.
4 kwi 2021 · MGMT01#show ntp status. Clock is unsynchronized, stratum 16, no reference clock. nominal freq is 250.0000 Hz, actual freq is 250.0000 Hz, precision is 2**10. ntp uptime is 55414000 (1/100 of seconds), resolution is 4000.
4 lis 2013 · Clock is unsynchronized, stratum 16, no reference clock. nominal freq is 119.2092 Hz, actual freq is 119.2092 Hz, precision is 2**19. ntp uptime is 26320700 (1/100 of seconds), resolution is 8403.
5 maj 2015 · Konfiguracja synchronizacji czasu z NTP na urządzeniach Cisco. K onfiguracja NTP na urządzeniach Cisco, na samym dole jest tabelka ze strefami czasowymi. #show ntp status. Clock is synchronized, stratum 2, reference is 10.XxX.YyY.101. nominal freq is 286.1023 Hz, actual freq is 286.0868 Hz, precision is 2**21.
19 wrz 2024 · The most accurate clock available is referred to as a Reference clock or a Stratum 0 is a clock source. If a computer within a network obtains its clock from a Stratum 1 source, its clock would be considered a Stratum 2 time source and so on up to a maximum of a Stratum 15 (Stratum 16 is equivalent to no external clock at all).
7 lip 2014 · NTP (Network Time Protocol) is used to allow network devices to synchronize their clocks with a central source clock. For network devices like routers, switches, or firewalls this is very important because we want to make sure that logging information and timestamps have the accurate time and date.
