Search results
21 lis 2023 · WSJT-X complains that there is an error in his audio input device. I logged in to his PC, verified his settings, and tried everything I could think of but my luck wasn't any better than his. I figured I'd start by posting here to see if anyone else has had this same problem.
13 maj 2019 · Using Ham Radio Deluxe for CAT (configured as FT991A), and using the internal sound card via the Yaesu drivers. I had CAT working fine, and WSJT-X was receiving fine, and putting the radio into transmit, but no signal transmitting.
It says there is "an error opening the audio input device" which I have set as the USB Audio CODEC from the radio. I have tried reinstalling the driver from Yaesu. Anyone have any suggestions?
20 cze 2023 · The issue is the drivers that are assigned to the HRI-200 vs the actually and correct drivers. You will need to manually install the correct driver for the device as compared to deleting it. If you just delete it the chances of the wrong driver being selected again is possible.
1) If you get errors during startup of the software, you may be using the wrong drivers for the comport from Yaesu. Open Google, search for Yaesu FTDX10 (or what ever rig you are using) and then click on the Files Tab.
4 gru 2022 · I installed the driver that Yaesu offers, name PL23XX_Prolific_DriverInstaller_v402, and I'm plugging it to a USB port in my computer using the cable that came with the Yaesu FT5D and then I get this error:
26 lis 2018 · Audio is not passed using the USB UART Bridge CAT/CI-V interface, it is strictly used for radio commands. WSJT-X uses a small set of messages over the CAT interface to control the radio. These include band changing, VFO frequency, PTT and a few others.
