Search results
This view shows the X,Y work zero grid from above. The work part zero for the Z-axis is usually set at the top of the part surface, and this will be entered in the tool length offset as a negative value for each tool. The range of Z-axis travel on the HAAS VF-1, for example, is 20 inches total; four of these inches are above tool change ...
- Y-AXIS LATHE APPLICATIONS TRAINING
Y-Axis Travel Limits. Each Haas Y-Axis lathe has +/- 2.00”...
- Y-AXIS LATHE APPLICATIONS TRAINING
Y-Axis Travel Limits. Each Haas Y-Axis lathe has +/- 2.00” of travel. There is a narrow corner of the work envelope, where a positive Y-Axis movement is constrained, as the X-Axis reaches its physical limit. This area is marked as “B” in the diagram to the right.
23 cze 2020 · This document has sample ballbar plots from machines with different geometric, dynamic and test hardware errors. Each sample includes a description of the error, the possible causes of the error, the effect that the error has on the machined part, and corrective action.
Align the Y axis perpendicular to the X Axis: Setup the tri-square granite on the left side of the C Axis platter on the machinist jacks. Set the back side of the tri-square granite parallel to the X Axis.
Leveling of the machine is required to obtain the correct right angle geometry of the machine's X, Y, and Z axes, and to ensure the correct positioning of the tool changer. Incorrect level will result in out-of-round circle milling,
Mini Mill 2/Super Mini Mill 2 Table Dimensions 6X ø0.328" (8 mm) Thru C’bore ø0.625 0.002" (16 0.05 mm) x 1.69" (43 mm) Deep +- +-2X 1.225" = 2.45" (2X 31 mm = 62 mm) NOTES: Top View 1. Table positions at Max X & Y travels 2. Measurements are from the edge of Mill Table to nearest obstruction (i.e. enclosure, way cover, door, etc.) 1.60 ...
This diagram shows a front view of the grid as it would appear on the mill. This view shows the X and Y axes as the operator faces the mill. Note that at the intersection of the two lines, a common zero point is established. Fig. 1-4: Operator’s working grid.
