Search results
Align the Y axis perpendicular to the X Axis: Setup the tri-square granite on the left side of the C Axis platter on the machinist jacks. Set the back side of the tri-square granite parallel to the X Axis.
12 sie 2012 · Loosen the Y axis blocks under the saddle that runs on the Y axis guides. This will allow you to adjust the X axis so it is square with the Y axis. That machine looks like it should have 4 blocks to loosen.
Y-Axis Travel Limits. Each Haas Y-Axis lathe has +/- 2.00” of travel. There is a narrow corner of the work envelope, where a positive Y-Axis movement is constrained, as the X-Axis reaches its physical limit. This area is marked as “B” in the diagram to the right.
Settings 45-48, 80 and 250 enable mirror imaging about the X, Y, Z, A, B, and C axes. The mirror pivot point along an axis is defined by the Xnn.nn argument. This can be specified for a Y Axis that is enabled on the machine and in the settings by using the axis to mirror as the argument.
Press the desired axis (+X, -X, +Y,-Y, +Z, -Z, +A/C or -A/C, +B, or -B). There are different increment speeds that can be used while in jog mode; they are .0001, .001, .01 and .1. Each click of the jog handle moves the axis the distance defined by the current jog rate.
To check the axis of rotation, check a single point at four positons, 90° apart on a 1-2-3 block, as shown in the illustration. Rotate the platter 90° CW, then jog the X and Z axes to the indicating point. Check the block in the same spot, record the reading, and repeat the procedure every 90°.
Mini Mill 2/Super Mini Mill 2 Table Dimensions 6X ø0.328" (8 mm) Thru C’bore ø0.625 0.002" (16 0.05 mm) x 1.69" (43 mm) Deep +- +-2X 1.225" = 2.45" (2X 31 mm = 62 mm) NOTES: Top View 1. Table positions at Max X & Y travels 2. Measurements are from the edge of Mill Table to nearest obstruction (i.e. enclosure, way cover, door, etc.) 1.60 ...
