Search results
5 paź 2024 · So I recently installed a bunch of wads onto my soft modded ntsc wii. I have priiloader región free and video mode to system default in loader settings. All...
5 paź 2024 · I dumped my emuNand using the built in option in USB Loader GX. Then used the emuNand WAD manager to install my WAD. It shows up in the game list to launch, but when I do so the game says “Your system file has been corrupted, please redownload and try again.”. Completely new to this.
5 paź 2024 · The WADS load up and the controller stays connected. However, after a few seconds, it kicks me back to the USB loader gx page. Are there any settings that need to be changed in the in-game settings?
I made game forwarder WADs using WiiGSC/Crap, and I get an error about loading IOS58 when I try to load them. This is because USB Loader GX 3.0 rev 1272 uses IOS58 by default, causing AHBPROT issues. The easiest way to fix this is to revert down to 3.0 rev 1271, which can be found on the USB Loader GX SourceForge.
8 sty 2018 · Connect the USB cable only when prompted and follow the on-screen instructions to complete the setup. Now restart the computer and then try to print and check how it performs. If the issue persists, I would suggest here is to try using the windows built-in drivers instead of the original printer drivers.
Troubleshoot the printer USB connection. Check the USB cable for damage and recommended length, and then restart your printer and computer. Turn off the printer and the computer. Disconnect the USB cable from the computer and printer, and then inspect the cable.
5 paź 2024 · It sounds like you are trying to boot SMB and it is crashing back out to whatever you loaded USB Loader GX from. That's the only explanation I see. Go into the Settings and make sure that you are trying to launch it using emunand instead of neek2o.
