Search results
understand this manual before attempting to install. As the set up and wiring of this version is quite different from previous versions of Siemens Elevator Starters, it is equally important to read even if you have a good working knowledge of the 72E version. If questions arise,
Starter controls the current during the start and provides overload, current imbalance, reverse phase, single phase and shorted SCR protection. In addition to those faults, on power up the starter will check the motor configuration.
Read this page before any work is performed on elevator equipment. The pro-cedures contained in this manual are intended for the use of qualified elevator personnel. In the interest of your personal safety and the safety of others, do not attempt any procedure that you are not qualified to perform.
To reset the starter, press the right key followed by the up key and the left key. The starter may also be reset by pressing both the Up and Down keys at the same time or Reset Fault by cycling the control power.
• Refer Table A for recommended selection of 3TW72 starters. Table A: kW/HP Rating, Contactor MLFB’s, thermal overload relay range & fuse rating, Coil Voltage, Maximum full load
View and Download Ultra Start 72 SERIES 1272 owner's manual online. Advanced Remote Starters & Vehicle Security Systems. 72 SERIES 1272 remote starter pdf manual download. Also for: 72 series 1172, 72 series 3272, 72 series, 1172 series, 1272 series, 3272 series.
Installation Instructions Part # 17764, 17780 & 17782 Lever Action Starter Solenoid 1. Disconnect the battery negative lead. 2. Remove primary chain cover. 3. Disconnect wires from the starter solenoid. 4. Depress the retainer cap and remove the pin and spring. 5. Remove the old solenoid. 6.
