Search results
Phase 1 of this study examines steel-to-steel screw connections in shear, with a data set of 702 strength tests from 9 different reports. The observed strength from these tests is compared to the calculated strength according to the AISI S100 to determine the viability of the current provisions.
This manual is intended as a guide for field welding and cutting cement-mortar lined and unlined Ductile Iron Pipe. For welding or cutting special lined pipe, consult the pipe manufacturer.
17 sie 2005 · With correct preheat & control of interpass temp (plus furious peening of the weldment) ductile CI usually welds well to mild steel. Ductile CI behaves much like mild steel, as it has the lowest shrinkage of any of the CI's. Specialty rods are available for "cold welding" cast iron.
Detailed standards for Ductile Iron Pipe, fittings, and appurtenances are available from the American Water Works Association (AWWA). Standard ANSI/AWWA C600, “Installation of Ductile Iron Mains and Their Appurtenances,” includes much of the information outlined in this guide. AWWA Manual M41 on Ductile Iron Pipe
In contrast to a ductile cast iron tested in a previous work, the bull-eye ductile cast iron with 700 MPa ultimate tensile strength presented better results during the post-welding heat treatment than during preheating.
27 sie 2024 · In particular, the dissimilar welding joints of ductile cast iron to stainless steel have attracted much attention due to cooperative advantages such as high strength, corrosion resistance,...
1 maj 2007 · The new welding procedure reduced the thickness of the carbidic fusion zone from 0.6 mm to less than 0.3 mm and the technique was found appreciable to both ferritic and pearlitic ductile iron.
