Search results
1 Ensure that your DLR-M system is correct for your flow capacity (see Flow Rate Tables in Technical Specifications.) 2 Ensure that your water supply meets water quality standards as shown in the table
The reset button is used to restart the Pumptec-Plus from a tripped condition. Pressing the reset button for less than ten seconds has no effect on the calibration.
How To Diagnose & Fix a Water Pump That Won't Start or Won't Run. This article explains inspecting, cleaning, and possibly repairing a typical Water Pump Pressure Control Switch or other controls or problems when a water pump or well pump won't start or won't run.
Find pump troubleshooting help for common pump problems, including clogged nozzles or filters, leaks, worn seals, and more.
Power Indicator Light. If solid, the Pumptec has power and the system is idle. In this state, the motor is not running and the Pumptec is waiting for the control device (i.e. pressure switch) to close and turn on the motor. When fl ashing, the system is pumping water and running normally.
The reset button is used to restart the Pumptec-Plus from a tripped condition. Pressing the reset button for less than ten seconds has no effect on the calibration.
INSTALLATION INFORMATION. WARNING: To avoid possible fatal shock, disconnect power at the main power panel before installing, wiring, or servicing Pumptec-Plus. CAUTION: This product does not replace a motor control box or the need for motor overload protection.
