Search results
Model 3 2024+ Service Manual; Release Notes. Current Release Notes; Release Notes Archive. Release Notes October-December 2023; Release Notes January-March 2024
Bracket - Retainer - Busbar - Charge Port to HV Battery (3-Phase) (Remove and Replace) Busbars - Charge Port to HV Battery (Remove and Replace) Busbars - Charge Port to HV Battery (China) (Remove and Replace) Busbars - Charge Port to HV Battery (3-Phase) (Remove and Replace) Charge Port and Busbar to HV Battery (Single-Phase) (Retrofit)
17 cze 2019 · Dec 5, 2020. #7. there is no OBD port as the regs require one for emissions testing, obviously with no emissions it's legally not required. You need an adapter lead that fits behind the small panel underneath the rear USB ports, use a trim tool to remove it.
17 mar 2023 · This is a guide on how to connect Tesla Model 3 & Model Y with Autel TESKIT Cable for diagnosis. Compatible with Maxisys tablets such as Autel Ultra, MS909, MS919, Elite 2, MS906S, MS906 Pro, MS906 Pro-TS, MS908S, MS908S Pro, MS906BT, MS906TS, MS906, D1 Pro. Location of X930. Connection Guide.
Location of the diagnostic connector in the Model 3: The Model 3 diagnostic connector is located at the rear of the center console, under the air vents, and can be accessed from the rear legroom after removing the rear center console cover.
14 lip 2019 · The OBD port in the Tesla Model 3 is a standard 16-pin port, similar to those found in most vehicles. It is typically located below the steering wheel or in the center console area. The OBD port allows for communication between the vehicle’s systems and an external device, such as a diagnostic tool or software.
Do not connect a DoIP OBD-II J1962-to-Ethernet cable into an OBD-II J1962 ancillary port that does not support DoIP. Doing so may cause damage to electronic equipment. The location and cable are different depending on the vehicle model and when the vehicle model was produced.
