Search results
7 wrz 2010 · 73-86 half-ton pickup used 28 and 31 splines axles and the 31 spline version should be considered the strongest available and can be used for extreme duty applications. Note: After 1970 all axles were the 31 spline style big axles. For 28 spline units the last 4 inchs were machined down for the 28 spline ends. If you shorten the axles more than ...
1 cze 2007 · You have to convert it to overslung by adding new spring perches ontop of the axle. It gives you about 4-1/2" in the rear. I also have 2-1/2" spacers in the front with 300# springs. Also did a full subframe/ diff drop and lowered the engine and trans 2" to keep good driveshaft angles. I also run 25" and they rub a bit. Need to do a bit of trimming.
2nd Taper: 1.551" (22.5" and 25.375" respectively different length shafts). 2nd taper is right at the snap ring near end of shaft. This holds the anti-lock ring (maybe pressed on) and pressed bearing in place while the flange cap is bolted to the rear axle.
View and Download Suzuki Carry Pro manual online. Carry Pro trucks pdf manual download.
26 mar 2020 · Land Cruiser rear axles are all offset to the passenger side. Minis and 4Runners have a front passenger offset and are centered in the rear. If you decide to run 60 axles in your mini, your driveshaft will run from the center of your truck to the passenger side.
11 sie 2010 · Without going out and measuring (which I may just do) I couldn't tell you the width measurement, but no, both pre and post 88.5 are the same width. The Wheel mount to wheel mount measurement is in the FAQ in the zuk forum. http://www.pirate4x4.com/forum/showthread.php?t=724181.
4 lut 2013 · I'm trying to decide between using a toyota mini truck axle with Ifs hubs and an ifs rear (58" WMS), or the FJ80 front I already have (63.5 WMS) and an ifs rear with 2" spacers.
