Search results
The Easy Flash Module 3.0 has three connections: The vehicle interface connector, switch interface connector and micro USB port. The module also features a multicolor status LED to display the current module mode.
This harness provides two ‘flying lead’ input wires. Both wires are inputs and can accept a 5 – 17 volt input signal from a switch or light controller of your choice. The white wire corresponds to switch input 1 and the green wire corresponds to switch input 2. Page 9: Pattern Selection
Refer to the installation guide of the unit to which the switch is to be connected for any specific installation instructions and fuse rating. Typical wiring diagrams are shown in the figures below.
28 gru 2016 · Most 3 speed switches are just a spdt center off switch. Do you know how to use a vom to test the wires from the switch? Hook the controller common wire to center terminal, and the other 2 wires to each side.
This manual describes the features and operation of the Easy Flash Module 3.0 (EFM 3.0) with software version V3.10. Speed Turtle Engineering recommends you always run the latest available EFM 3.0 software. The latest software is available for download at SpeedTurtleEngineering.com.
25 lis 2022 · Their wiring diagram makes it pretty clear: Essentially there are power wires and speed wires. Shared ground, and shared neutral. The power wires stay connected all the time, and the thing to attach the relay t...
Snaptroid 2.0. Mobile device required. Snaptroid 2.0 is developed by the talented team at Spdm and CodeX, It is offers a host of features for iOS And Android.
