Search results
22 gru 2012 · Spin the hub while tightening until it gets tight, then back off a little and retighten till finger tight. Install the castle retainer and cotter pin. Check that the hub spins freely but has no play in the bearing.
Guys: Been through this on multi UFP/ Vault Hubs. 2014 Ranger Trail. All advice on here is correct. But, do yourself a favor and go to UFP/ Vault site/ see link below/ and know what the parts are and how to disassemble and reassemble before tackling.
3 sie 2018 · Current Ranger brochure says they are Cool Hubs. The hubs are covered by a cap so I could not see the hub from the outside.
Demonstrating how I drain, clean, and refill Ranger trailer Cool Hub on a 2004 model trailer for a VX series boat. Note that there are different designs for...
26 maj 2016 · I recently decided to perform a removal and inspection of the cool hubs and bearings on my 1998 Ranger Trail boat trailer (1998 Ranger Trail D4600). I’ve documented the entire process of Cool Hub Removal and Inspection here, I hope it helps walk you through this basic maintenance procedure.
The project for today is inspecting my cool hubs on my 2009 Ranger Bass boat. I noticed one of my hubs was leaking through the rim cap and that is never good...
8 maj 2005 · I was just over at the storage working on my boat and noticed I have a cool hub leaking oil. I must have happened on the drive out. Its not cold temp related as the boat is in a constant 65 deg underground storage. So how do I fix this thing? Is it something that can be done myself? Thanks Gary
