Search results
ARPMiner can be used as a HotSpot system, NAT gateway and a PPPoE Server. ARPMiner consists of a GUI and a service application called TekSpot that provides PPPoE, HTTP, DHCP server and a proxy DNS services.
PPPoE Configuration With Packet Tracer. Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol which encapsulates PPP frames inside Ethernet. PPPoE is a Client/Server protocol and it allows divided multiple clients to use a single server connection.
20 gru 2019 · Configuring the interface with an incorrect MTU size can cause some websites to not load and Internet speed to decrease. This article describes what is the optimal MTU size for PPPoE connections and its reason.
Use the Point-to-Point Protocol over Ethernet (PPPoE) encapsulation to connect multiple hosts on an Ethernet LAN to a remote site via a single customer premises equipment (CPE) device. This topic provides an overview of PPPoE and explains how to configure PPPoE, verify the configuration, as well as trace PPPoE operations.
26 sie 2024 · This article describes the outages that occur when the PPPoE client receives no response to LCP (Link Control Protocol) Echo Requests from the server. PPPoE (Point-to-Point Protocol over Ethernet) can have disconnect issues for a variety of reasons.
Using PPPoE, Alcatel-Lucent users can dial from one router to another over an Ethernet network, then establish a point-to-point connection and transport data packets over the connection. In this application subscriber hosts can connect to the router using a PPPoE tunnel.
Packet loss with many (small) UDP packets¶ If a lot of packet loss is observed with UDP on bce cards, try changing the netisr settings. These can be set as system tunables under System > Advanced, on the System Tunables tab. On that page, add two new tunables:
