Search results
Units of density. The SI unit of density is kg/m 3. The density of the various states of matter is given by: g/cm 3 – for solids. g/mL – for liquids. g/L – for gases. For plastics, it is normally expressed as g/cm 3.
Use our plastics properties table to sort and compare plastic materials. Review typical, physical, thermal, optical, electrical properties. Ask an Expert or Get a Quote.
3 paź 2023 · ASTM D792-98 describes establishing solid plastics’ specific gravity and density in forms like rods, sheets, tubes, or molded items. There are mainly two methods involved in the process: Test Method A – For testing solid plastics in water. Test Method B – For testing solid plastics in other liquids.
Definitions, online calculator and figures and tables with water properties like density, specific weight and thermal expansion coefficient of liquid water at temperatures ranging 0 to 360°C (32 to 680°F).
Densities, tensile strength, elongation, Youngs modulus and Brinell hardness. Physical properties of some common plastic materials are indicated below.
Density of water is highest at 4°C i.e. 1g/cm3. So Specific Gravity of less than “1” means that the material will float in water. WaterAbsorption- 24 Hours (%) Water absorption is used to determine the amount of water absorbed under specified conditions. Water absorption is expressed as increase in weight percent.
GAP Polymers provides you with this table below that contains the main 7 types of plastic density that are calculated by dividing the mass of the material by the volume and is expressed normally in g/cm3.
