Search results
3 lut 2023 · Is there a video or a post that gives you step by step setup to configure the computer to see the controller.
The kicker is when I buy the new board that new board will not be compatible with the old software version, so, long story, they are recommending an upgrade from the old DHC to a new DHC2 for about $7000USD+.
PlasmaCAM’s DesignEdge ® software was developed specifically for plasma cutting and is the most important part of the system. This complete Windows-based CAD/CAM program not only creates designs, it also runs the machine (no other software programs are needed).
• Wireless connection (rather than by parallel port). Provides much wider computer compatibly, since wifi hardware is common and inexpensive to add to any PC (including laptops). No more cable between computer and machine to damage, trip over, or cause electrical/grounding problems and communication errors.
If you're running a new Hypertherm 65 or 85, it's possible to run a machine torch with a dedicated control cable which, does away with having to splice wires internally as has to happen with the hand torch and, also allows rapid torch changeover from machine to hand cutting.
1 wrz 2023 · If you have a WiFi dongle on the computer try unplugging and/or disabling it. Try turning off any nearby mobile phones. If you are using wireless or Bluetooth keyboard & mouse, try swapping these for corded ones.
7 cze 2017 · I do agree with PlasmaCam's concerns about remote access to a DE computer, but they could have addressed the problem in a different way. I used to train people on how to use DE, using Team Viewer, which was fantastic for remote online training use.
