Search results
If the barrel shroud needs an adjustment to line up with the marker body, follow these steps: 1. Locate the two set screws that hold the shroud in place, they are located on the right side of the shroud, when the barrel is pointed away from you. a. The first is located on the front sight, in line with the barrel. b. The second is along the side ...
Always fit a barrel-blocking device to the ETHA2 when not in use. Always remove paintballs from the ETHA2 when not in use. Do not field strip or remove any parts while the marker is
Use a closer paintball to barrel bore size. If an issue with the MG 100 cannot be solved using the fault finding guide, contact your nearest Eclipse Service Centre for assistance. MG 100...
Barrel Installation - While pointing marker in a safe direction, place the threaded end of the barrel into the front opening of the marker body. - Turn the barrel clockwise until it stops (do not over tighten). - Install a barrel-blocking device which is included. This can be a barrel plug or other such
- Ensure you have a barrel sock or other specifically designed barrel-blocking device in place. - Make sure there are no paintballs in the marker and that the AXE is turned OFF. Notes:
Barrel Adapter from the Foregrip/Shroud. Pull on the Phenom Barrel Adapter to remove the barrel from the Foregrip/Shroud. Remove the set screw using a 3/32" Allen wrench. Put the set screw into the )(7 Barrel Adapter, turning it no more than four full turns. Remove the Phenom Barrel Adapter by twisting the adapter back and forth while pulling ...
Step 1: Step 1 Materials. - 1-1/4" PVC pipe. - Two rubber bands. - Flat black spray paint (not pictured) - Your Paintball Gun. Step 2: Step 2 Assembly. First, cut the PVC to the size of the part of the barrel that sticks out. Spray paint the PVC pice flat black. In my case I have a Smart Parts SP1 with a CP barrel, and so I measured About 6-1/2"
