Search results
The criteria and practices requirements for guardrail systems on scaffolds are contained in 29 CFR part 1926, subpart L. Figure D-11 -- Guard Rail Systems. Depicts two figures showing two types of Guard Rail Systems. The first shows the walking-working surface, posts, and mid rail for guard system.
Guardrail systems. Guardrail systems and their use shall comply with the following provisions: 1926.502 (b) (1) Top edge height of top rails, or equivalent guardrail system members, shall be 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level.
Where workers on a construction site are exposed to vertical drops of 6 feet or more, OSHA requires that employers provide fall protection in one of three ways before work begins: Placing guardrails around the hazard area. Deploying safety nets. Providing personal fall arrest systems for each employee.
The employer must ensure guardrail systems meet the following requirements: (1) The top edge height of top rails, or equivalent guardrail system members, are 42 inches (107 cm), plus or minus 3 inches (8 cm), above the walking-working surface.
Guardrail systems and their use shall comply with the following provisions: (1) Top edge height of top rails, or equivalent guardrail system members, shall be 42 inches (1.1 m) plus or minus 3 inches (8 cm) above the walking/working level.
The employer must ensure: (i) Each employee less than 4 feet (1.2 m) above dangerous equipment is protected from falling into or onto the dangerous equipment by a guardrail system or a travel restraint system, unless the equipment is covered or guarded to eliminate the hazard.
Guardrails meeting the requirements of paragraph (g)(4) of this section shall be provided on the open sides and ends of each landing. 1926.451(e)(4)(xiii) Riser height shall be uniform, within ¼ inch, (0.6 cm) for each flight of stairs. Greater variations in riser height are allowed for the top and bottom steps of the entire system, not for ...
