Search results
An 80-10 end-fed half-wave antenna can be a very good performing part of an HF station. But its performance depends heavily on a well-designed and carefully constructed 49:1 unun, which matches the long wire impedance to within tuning range of operation. But the perfor-mance of an end-fed antenna is also very dependent on height above ground.
This project assembles a 49:1 ferrite-core (“FT”) type #43 transformer that matches 50 ohm input to 2500 ohm end fed antenna. It is optimized for 3.5/7/10/14 MHz but will work reasonably well on all amateur bands from 80 meters thru 10 meters with a 135 foot length of wire and a short connection to ground.
Detailed Build Instructions for the 80-10 end-fed half-wave antenna with 49:1 unun: Noji-Article-80-10-EF-HW.pdf Source: https://noji.com/hamradio/pdf-ppt/noji/Noji-Article-80-10-EF-HW.pdf
22 lut 2021 · The following is a list of materials required to make a 49:1 unun impedance transformer for an end-fed half wave antenna. You will also need a half-wavelength length of wire (14 or 12 gauge typically) in order to construct an antenna radiator for whichever ham band you choose.
4 sie 2020 · This is the page on the End-Fed Half-Wave antenna with a 49:1 transformer. This is a multiband antenna without the need for any tuner (which is the best type of antenna).
Installation Tips. Weather you bought one of our multiband models like the EFHW-8010/7510, EFHW-4010 or a transformer like the MEF-330, MEF-107 etc. these basic rules apply to any antenna installation. All antennas need to be as far as possible from ground, antennas, wires, homes and similar.
Figure 2 shows the complete schematic view of a typical EFHW antenna system. Briefly, the 100pf/2kv cap across the primary of the impedance matching transformer is there to allow better tuning in the 10 meter band. The transformer is a step-up with an impedance ratio of 49:1, and wound on a type 43 toroid core.
