Search results
Either should preform as well as the larger Mocal Laminova or like a 30 row oil to air cooler and will give way more consistent temperature regulation and oil pressure drop than the stock coolers (especially when the oil to water ones are installed without a thermostat)
Wondering if anyone has experience, advice, or their two cents to throw in about low-temp oil cooler 'stats. The stock ones have an opening temp of 194 °F. These aftermarket ones from Rotary Performance open at 165 °F.
These coolers, built to our specification since 1965 must rate as the single most commonly used component on racing cars world wide. The cooler consists of a variable number of aluminium pressed plates forming oil ways and end tanks, the oil ways contain turbulators.
RP offers this Oil Cooler Thermostat to lower oil temperature in you RX-8 Renesis rotary engine! Easy upgrade is easy to install.
Mocal Oil Cooler. Oil coolers are necessary on tuned and high performance engines. As temperature rises, the oil gets thinner which reduces the lubricating properties. To keep the oil temperature at around 80 degrees celcius, it may be necessary to fit a Mocal oil cooler.
Performance Oil Cooler Kit. $949.00. Designed as a complete replacement of the factory equipment, our high performance oil cooler kit provides substantial improvements over the factory units. We include a 175f thermostat to ensure the engine reaches operating temperature and utilizes a bypass system to allow approximately 15 percent of the oil ...
I've said it before, if you're going to start doing real cooling mods/upgrades in the 2020s go with an oil to water cooler, no thermostat, and an upgraded radiator. Personally I have had very good results with an RX7 FC TII oil cooler mounted in front of the ac condenser, but I would not go that route again.
