Search results
Reset There are two ways to reset the Router’s factory defaults. Either press and hold the Reset Button for approximately five seconds, or restore the defaults from Administration > Factory Defaults in the Router’s web-based utility. Internet The Internet port is where you will connect your cable or DSL Internet connection.
7 mar 2019 · Once you see the blinking power light & the wlan light go off, release the reset button. Once the wlan light comes back on, your router is booted and will be set to defaults (assuming your button is functioning).
20 lut 2009 · To reset your router, use the following steps: Press the reset button for 30 seconds. This can be done by using an object with a small tip, such as an unfolded paper clip. At this point, all settings that you had previously saved have now been deleted. You will now need to re-secure your WRT54GL Wireless-G router.
23 sty 2008 · Press the reset button for 30 seconds. The settings should now be returned to the factory default settings, meaning any changes you had made would be deleted. Open up your Web browser and enter “192.168.1.1” in the address bar. For the login, leave a blank ID and enter “admin” as the password. The router has now been reset.
This article will show you how to change or reset the router password using the recovery key on the router’s product label if you can’t log in to your router using your admin password.
To start over, I need to set the Router to factory default. Hold the Reset button for 10 seconds and then release it. This will return the password, forwarding, and other settings on the Router to the factory default settings. In other words, the Router will revert to its original factory configuration. Page 75 Wireless-G Broadband Router 15. I ...
If you run more than one DHCP server on your network, you will experience network errors, such as conflicting IP addresses. To disable DHCP on the Router, see the DHCP section in “Chapter 6: The Router’s Web-based Utility.”. This User Guide covers the steps for setting up a network with the Router (see Figure 1-1).
