Search results
In order to use the fan as a desk fan/light, you will have assemble the fan to the base by following the below instruction: 1.Located the mounting socket on the bottom of your fan and carefully fasten the mounting screw on the stand to the mounting socket on the fan. Turn clockwise to fasten the fan or anticlockwise to loosen it. Rubber mount piece
Locate the two light kit wires from the fan assembly. Attach the light wires from the light bracket to the light wires of the housing (White to White, Black to Blue) using the wire nuts provided.
Please read and understand this entire manual before attempting to assemble, operate or install the product. • Always disconnect the power supply prior to servicing the fan, motor or junction box.
NOTE: Wiring diagram includes the light kit wiring. The light wiring diagram and switch is omitted when no light kit is used with the ceiling fan. WIRING DIAGRAM: For installations using wall control only After completing the electrical connection at the mounting bracket terminal block, connect the ceiling
Check line wire connections to the fan and switch wire connections In the switch housing. Check to make sure the dip switches from the remote control and receiver are sat to the same frequency. PAGE 18
29 lis 2018 · Use a wire nut to connect the panel white neutral to the neutral wire going to the fan/light. In the fan/light junction box, connect each switched hot to one of the hot wires on the fan/light. Note that the colors may vary - typically black, red or blue.
CHANGING THE COLOUR OF THE LED LIGHT (For models with light kit) NOTE: Always turn OFF the power at the mains switch before attempting to change the Light output on your ceiling fan. You are able to select/change the colour output of the LED light on your EVO II Ceiling fan. 1. Loosen the screw (A) to lift the top housing (B) 2.
