Search results
Aby zatrzymać wszystkie własne procesy, wprowadź następującą komendę: kill -9 -1. Ta komenda wysyła sygnał 9, sygnał SIGKILL , do wszystkich procesów, których właścicielem jest efektywny użytkownik, nawet tych procesów, które są uruchamiane na innych stacjach roboczych i które należą do innych grup procesów.
kill -s KILL %2 pid Is the process ID that the shell reports when a process is started with &. You can also find it using the ps command. The pid argument is a number that may be specified as octal, decimal, or hex. Decimal process IDs are reported with default actions. kill supports negative values for pid.
To kill the job report in job stream apwkly(0600 03/05/06) on workstation site3, run the following command: kill site3#apwkly(0600 03/05/06).report
9 mar 2010 · A straight "kill" should be used first. Wait a few minutes and give the system time to gracefully kill the process. If that does not work a "kill -9" can be done, but be aware that it may
13 mar 2012 · You can use this command to kill it: db2 force application (xx) Where xx is the ID (or a comma-delimited list of IDs). Here is the DB2 for Linux/Unix/Windows v9.7 Information Center article on FORCE APPLICATION, and here is the one for LIST APPLICATIONS.
3 mar 2007 · then try the command again to make sure that it is killed: ps -ft pts/0 | grep -v grep otherwise, use kill -9 688328 (which is not advicable by the way but it does the job!)
To stop several processes that ignore the default signal, enter the following command: kill -kill 2098 1569. This sends signal 9, the SIGKILL signal, to processes 2098 and 1569. The SIGKILL signal is a special signal that normally cannot be ignored or overridden.
