Search results
12 paź 2018 · Anyone know of an easy way to install the axle roll pin that holds the stock to the reciever. I just slowly tapped mine in from the top with a smooth finish hammer and finished it with a punch, But i'm a idiot. Hello from Bend fellow Oregonian. If you don’t already have one, get a nylon head mallet.
26 sty 2018 · stock block conversion aligned with G36 receiver with G36 stock installed. Alignment is at the lower front push-pin hole and comparison point is the stock hinge. Approximately 20 mm of extra length are evident on the stock block conversion.)
This is the axle pin that holds the G36 or G36C folding stock to the rear section of the receiver. Also used to mount the US-made rear stock block for those who are doing the SL8 to G36 type conversions.
the pins which have removed Another eyelet for the slõg is provided at the rear of the butt stock. pad Fig. 10: Buttstock Magazine well The front of the magazine well into two supp.t studs on the receiver. For fastening the magazine well is swiveled upward. A locking pin fastens txflh the grip and the magazine well to the receiver.
Take out the rear system pin by pushing it out of the receiver to the right. Push the buttstock locking button and fold the buttstock to the right. Push the guiding rod block with your right hand into the upper receiver and slide the pistol grip out of the receiver body. Finally separate the bolt group from the receiver receiver. group.
The G36K E is the short version of the G36 E Rifle, with shortened barrel and shortened handguard. The MG36 E Light Machine Gun is identical to the G36 E Rifle, with the
HKP HK G36, SL8 Forearm, Lower, Magwell U.S Push Pin - Black U.S. made G36 push pin finished in black oxide. This push pin is also required for converting the SL8 to a G36. G36's use three of these factory push pins per rifle whereas the SL8 has two.
