Search results
Configure Exec to use the NTP server with the following command: w32tm /config /manualpeerlist:192.168.0,0x8 /syncfromflags:MANUAL /update 5. Verify that the Exec computer is using the NTP server for time synchronization.
This document describes NTP version 4 (NTPv4), which is backwards compatible with NTP version 3 (NTPv3), described in RFC 1305, as well as previous versions of the protocol. NTPv4 includes a modified protocol header to accommodate the Internet Protocol version 6 address family.
19 wrz 2024 · You can configure up to 64 NTP entities (servers and peers). If you configure NTP in a VRF, ensure that the NTP server and peers can reach each other through the configured VRFs; If you are using the switch as an edge device and want to use NTP, we recommend using the ntp access-group command and filtering NTP only to the required edge devices.
Ordinarily, ntpd reads the ntp.conf(5) configuration file at startup time in order to determine the synchronization sources and operating modes. It is also possible to specify a working, although limited, configuration entirely on the command line, obviating the need for a configuration file.
Abstract. This document describes the Network Time Protocol Version 4 (NTPv4), which is widely used to synchronize the time for Internet hosts, routers and ancillary devices to Coordinated Universal Time (UTC) as disseminated by national standards laboratories.
14 wrz 2024 · The ntp.conf configuration file is read at initial startup by the ntpd daemon in order to specify the synchronization sources, modes and other related information. Usually, it is installed in the /etc directory, but could be installed elsewhere (see the daemon’s -c command line option).
This document is a collection of best practices for the general operation of NTP servers and clients on the Internet. It includes recommendations for the stable, accurate, and secure operation of NTP infrastructure. This document is targeted at NTP version 4 as described in RFC 5905.
