Search results
Ham Radio HF/VHF Antenna Lengths Chart. Here is a handy chart for determing 1/4 wave verticals, 1/2 wave dipoles, and full wave loop lengths. All antenna lengths in the information below are in feet and are the results based on the standard formula of 468 / FMhz = total length in feet.
2.1. Antenna length based on the following formulars: 1/2 λ dipole (feet)= 468 / frequency in Mhz. 1/2 λ dipole (meters) = 142.65 / frequency in Mhz. Full wave loop (feet) = 1005 / frequency in Mhz. Full wave loop (meters) = 306.32 / frequency in Mhz. Cut wire slightly longer for connecting insulators and pruning. 22-Jun-2007 09:30 AM.
For best results, use the longest wire shown on the table that will fit your installation constraints. Installing the antenna wire as an Inverted L can change the feed point impedance and may require tuning (changing overall length of the wire) for best coverage of all HF bands.
5 cze 2021 · Here is a simple antenna calculator for two popular forms of ham radio HF wire antennas: the horizontal dipole and the inverted "V". (Updated June 5, 2021) The Antenna Calculator for Half-Wave Dipoles
Table shows typical SWR relative to installed wire length. SWR will vary based on topography, proximity of nearby structures, configuration of the antenna wire and choice of ground or counterpoise. For best results, use the longest wire shown on the table that will fit your installation constraints. Installing the antenna wire as an Inverted L ...
1 wrz 2021 · This chart serves as an aid in trimming the length of HF antennas. The chart estimates, over the length of an approximate quarter wavelength, the required change in length to shift the fundamental antenna resonance by a specific amount of kHz.
With the 9:1 voltage unun and wire lengths suggested in the below tables the antenna should present non extreme impedances for all HF amateur band frequencies. This page is far from complete and represents the ongoing investigation into this type of antenna.
