Search results
Ham Radio HF/VHF Antenna Lengths Chart. Here is a handy chart for determing 1/4 wave verticals, 1/2 wave dipoles, and full wave loop lengths. All antenna lengths in the information below are in feet and are the results based on the standard formula of 468 / FMhz = total length in feet.
2.1. Antenna length based on the following formulars: 1/2 λ dipole (feet)= 468 / frequency in Mhz. 1/2 λ dipole (meters) = 142.65 / frequency in Mhz. Full wave loop (feet) = 1005 / frequency in Mhz. Full wave loop (meters) = 306.32 / frequency in Mhz. Cut wire slightly longer for connecting insulators and pruning. 22-Jun-2007 09:30 AM.
5 cze 2021 · Antenna Calculator for HF Antennas. Here is a simple antenna calculator for two popular forms of ham radio HF wire antennas: the horizontal dipole and the inverted "V". (Updated June 5, 2021)
In practice, to optimize NVIS (Near Vertical Incident Skywave) performance, deploy the antenna horizontally at a height of 1/8 wavelength on any given band for a 0–650 km (0–400 miles) coverage area. Where DX will occur into the greyline from 7.0-19MHz during evening or daytime deployments.
1 wrz 2021 · This chart serves as an aid in trimming the length of HF antennas. The chart estimates, over the length of an approximate quarter wavelength, the required change in length to shift the fundamental antenna resonance by a specific amount of kHz.
The Single Wire End Fed Antenna is probably the simplest antenna to use. But when you start looking around, you find that no one can agree on what length to use. Some say any length will work, some stress odd multiples of 1/4 wavelength, while others lean toward even multiples of 1/2 wavelengths. Some say design for the lowest frequency ...
19 sty 2017 · I want to use an end-fed wire antenna, but what would be the best length of wire for the 20m and 40m bands? Is there a way to work this out? This is assuming a tuner will be used.
