Search results
To purchase: http://www.thepumpoutlet.com/general-pump-18-surface-cleaner/ This is a demonstration of a General Pump Flat Surface Cleaner on a new concrete s...
Operating Instructions 1. Connect to Pressure Washer. 2. Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure that groove of nozzle is parallel to spray bar. Use thread sealant when installing nozzles. 3. Start Pressure Washer.
Operating Instructions 1. Connect inlet filter to FSC gun inlet. 2. Connect to Pressure Washer. 3. Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure that groove of nozzle is parallel to spray bar.
7 cze 2021 · In this video I give first impressions of the Hammerhead surface cleaner. This thing is going to make a lot of money and cut concrete cleaning down tremendou...
If the flat surface cleaner rotating arm is not spin-ning, tilt the flat surface cleaner up so you can see the underside of the deck. If a nozzle is not spraying it is plugged and needs to be cleaned. The best way is to do this is to remove the nozzle (9/16" wrench) and tap it on a hard surface (be careful not to damage the threads). Sometimes
Use No. 2 general purpose waterproof lithium grease. For hot water applications, use a high quality high temperature grease. NOTE: For the DCFSCP18GZ only: after 50 hours of use, remove the in-line filter, take apart and clean filter screen. DO NOT ALLOW MACHINE TO REMAIN STATIONARY ON SOFT SURFACES SUCH AS WOOD. STORAGE NOTE
Operating Instructions 1. Connect inlet filter, D40014 to FSC gun inlet. 2. Connect to Pressure Washer. 3. Turn water on and open valve. Open trigger gun for flow of water through nozzles. Nozzles must have flowing spray. If not, remove tips and clean; reassemble, making sure that groove of nozzle is parallel to spray bar.
