Search results
Read these instructions completely and carefully. The CLCINTxx is the interior for the Centralized Lighting Control System Relay Panel. WARNING. CAUTION: Make sure all power is off before wiring. Do not energize wiring until the unit is fully assembled. Conform to all applicable codes. Installation of the Relay Panel Interior.
General Electric's RR9 solenoid relay switch features an isolated pilot contact and is the recommended replacement part for older, discontinued GE pilot light relays. Featuring 5 six-inch low voltage leads with a new plug-in connector, this mechanical latching relay uses momentary 24 volt switch pulses to open and close line voltage circuits.
26 paź 2022 · The General Electric RR9 Solenoid Relay Switch with an isolated pilot contact is an ideal replacement for older GE pilot light relays. Its momentary 24-volt switch pulses manage the open/close line voltage circuits, making it an excellent choice for vintage Bryant and Sierra systems.
General Electric's RR9 solenoid relay switch features an isolated pilot contact and is the recommended replacement part for older, discontinued GE pilot light relays. Featuring 5 six-inch low voltage leads with a new plug-in connector, this mechanical latching relay uses momentary 24 volt switch pulses to open and close line voltage circuits.
GE RR9P%3 relays are mechanical latching-type devices for direct plug-in to a GE Lighting Automation Panel. Pilot contact provides status feedback through LED indicators mounted on INTRxxyy. They require only momentary 24 volt rectified AC switch circuit pulses to open or close line voltage circuits.
The GE RR9 solenoid relay switch features an isolated pilot contact and is the recommended replacement part for the following older, discontinued GE pilot light relays: RR4, RR6, RR8, and all discontinued Bryant relays for pilot lit switches.
The WIR-10-RR7-D allows the control of four GE RR7/9 relays or two Sierra 1070-B relays. The sensor may be interfaced to an energy management system that accepts either a normally open or normally closed dry contact via the sensor’s Form C relay.
