Search results
Pre-set Using the Fitting Body or Hardened Pre-assembly Tool. Pre-setting with the fitting body is only recommended for steel and copper tubes. For frequent pre-setting, stainless steel tube and hose standpipe fittings, a hardened pre-assembly tool (VOMO) is strongly recommended (see Fig. T40).
G-Series pipe thread chart (British standard pipe parallel was BSPP & BSPF) and PF-Series pipe thread chart (Japanese pipe parallel).
Standard Material Specifications: The standard materials used in the manufacture of Industrial Pipe and Adapter fittings are shown in Table G2. Note: Upon request, pipe fittings, adapters and plugs could be furnished in materials other than those shown in the material specifications chart.
During fitting makeup, 15° angles close — between the rear ferrule and nut, and between the rear ferrule and front ferrule — thus preventing overstress- ing of tubing or excessively reducing tubing inside diameter.
against the fitting body on the tubing outside diameter. As the nut is turned, the back ferrule: axially advances the front ferrule radially applies an effective tube grip. Advanced-Geometry, Hinging-Colleting Back Ferrule Design This design is standard on all 1/4 to 1 in. and 6 to 25 mm Swagelok stainless steel tube fittings to help
BSPP G 1/4 : Brith Pipe (BSP) Thread Dimensions and Tolerances. All the relevant data for this tread in one spot.
Parker offers the ISO 6149 male stud end, shown in Fig. G7, on several tube fitting products including: Seal-Lok, Triple-Lok, EO, EO-2, Conversion Adapters, Plugs, etc. This port, utilizes metric parallel threads for mechanical holding power and a sealing method similar to the proven SAE Straight Thread O-ring port.
