Search results
G-Series pipe thread chart (British standard pipe parallel was BSPP & BSPF) and PF-Series pipe thread chart (Japanese pipe parallel).
1/16 28 0.907 7.723 0.304 4 1/8 28 0.907 9.728 0.383 4 6 10.2 0.4 2 ... Gauge length [mm] OD [mm] Major diameter of the thread Corresponding pipe [mm] [in] DN OD [in] Title: British Standard Pipe Taper (BSPT) Threads Size Chart Author: Pyromation Inc. Subject: BSPT Thread
BSPP G 1/4 : Brith Pipe (BSP) Thread Dimensions and Tolerances. All the relevant data for this tread in one spot.
To get an accurate value, ensure that the thread pitch gauge is fitting well on the threads. Record the values and compare your measurements with the figures provided in this guide. Accurate measurement of four-bolt flanges. Begin by using a caliper to measure the port hole diameter the bolt.
Thread Pitch Gauge: Used to measure the number of threads per inch, as well as thread to thread spacing in the case of metric connections. Before you begin measuring, be sure the threads are in good condition.
Parker offers the ISO 6149 male stud end, shown in Fig. G7, on several tube fitting products including: Seal-Lok, Triple-Lok, EO, EO-2, Conversion Adapters, Plugs, etc. This port, utilizes metric parallel threads for mechanical holding power and a sealing method similar to the proven SAE Straight Thread O-ring port.
The BSPT thread chart calculator shows sizes, dimensions, tolerances and designation for jointing pipe threads for thread sizes from 1/16 to 6 according to ISO 7-1 standard. The thread form follows the British Standard Whitworth thread.
