Search results
View and Download Flotec FP7100 owner's manual online. Pre-Charged Pressure and Horizontal Tanks and Fittings. FP7100 water heater pdf manual download. Also for: Fp7100h, Fp7110, Fp7110t, Fp7110th, Fp7120, Fp7125, Fp7130, Fp7135.
- Flotec User Manuals Download
View & download of more than 478 Flotec PDF user manuals,...
- Flotec User Manuals Download
View & download of more than 478 Flotec PDF user manuals, service manuals, operating guides. Water Pump, Water Heater user manuals, operating guides & specifications.
Download 287 Flotec Water Pump PDF manuals. User manuals, Flotec Water Pump Operating guides and Service manuals.
SAVE THESE INSTRUCTIONS - This manual contains important instructions that should be followed during installation, operation, and maintenance of the product. This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the following signal words and be alert to the potential for personal injury!
If the pump is used in portable applications and the water has been drained from the pump case, re-prime before start-up. To prime, remove plug from top discharge outlet and fill pump with water. Replace plug and start pump. The pump will require a few minutes to evacuate air from the suction line.
Check the pre-charge of air in the tank with an ordinary tire gauge. The pre-charge should be 2 PSI less than the cut-in setting of the pump’s pressure switch. The pre-charge is measured when there is no water pressure in the tank. Your new pump has a 30/50 PSI switch, so adjust the tank pre-charge pressure to 28 PSI.
ng cream.Replace foot valve.Re-pipe using pipe the same size as suct. n pump.Existing installation:Check all connections on suction line. d shaft seal with soapy water.Lower sucti. n line into water and re-prime. If the water level is more than 25’ (7.6M) below the p. pump is needed.Either status.
