Search results
LAN PHYs (other than LAN78xx which can generate test patterns itself), use the link partner (set to forced 10BASE-T) to transmit the signal to the device under test (DUT) and enable remote loopback on the DUT.
The following instructions will show you how to configure the Ethernet Port on DPO DSA MSO 5K 7K and 70K Series Tektronix Oscilloscopes for proper use as a Link Partner. These instructions will be similar for any Windows based PC being used as a Link Partner.
13 wrz 2023 · This document provides a general description of auto-negotiation and explains the procedure to configure and verify auto-negotiation on Catalyst switches that run the Cisco IOS Software on both the Supervisor Engine and MSFC (Native).
16 lis 2018 · #1. I have a couple of nodes (PVE5.2-1) that have 10G cards in them, and the switch indicates they're bonded at 10G speed, but the pve nodes show 1000bps connections. Do I need to install a driver or set a speed on the interface to get it utilize the port properly?
11 kwi 2017 · The intention of link training is to reduce the system-level challenge of tuning settings for every channel configuration (long, medium, short). By allowing the receiver to tell its link partner transmitter what settings to use, the goal is to eliminate the need for channel-specific tuning.
1 lis 2021 · Decides whether the adapter or link partner is designated as the master. The other device is designated as the slave. Changing the setting can improve link quality with certain link partners.
In Windows* Device Manager, double-click the adapter you want to configure. On the Link Speed tab, select a speed and duplex option from the Speed and Duplex drop-down menu. Click OK. In Intel® PROSet Adapter Configuration Utility (Intel® PROSet ACU), link speed is reported on the Adapter Information panel.
