Search results
30 wrz 2020 · Part 1: Build the Network and Configure Basic Device Settings. Part 2: Create VLANs and Assign Switch Ports. Part 3: Configure an 802.1Q Trunk between the Switches. Part 4: Configure Inter-VLAN Routing on the Router. Part 5: Verify Inter-VLAN Routing is working.
16 maj 2020 · CCNAv7: Routing and Switching4.2.8 Lab - Configure Router on a Stick Inter VLAN RoutingVisit our Website to contact us: http://www.techacadhelp.comFollow us ...
15 lut 2020 · Objectives. Part 1: Add VLANs to a Switch. Part 2: Configure Subinterfaces. Part 3: Test Connectivity with Inter-VLAN Routing. Scenario. In this activity, you will configure VLANs and inter-VLAN routing. You will then enable trunk interfaces and verify connectivity between VLANs. Instructions. Part 1: Add VLANs to a Switch.
10 paź 2010 · How to Configure Cisco Router-on-a-stick with Switch. Edited By Harris Andrea. In this post I will explain how to provide routing between two VLANs on a simple Layer 2 switch using a Cisco router with just one interface. This is called also Router-on-a-stick.
In this lesson, I’ll show you how you can use a router connected to a single switch as a “router on a stick”. This is the topology we’ll use: On the switch, we have VLAN 10 and VLAN 20, and there’s only a single cable between the router and the switch.
25 paź 2021 · Router On a Stick : The Router’s interface is divided into sub-interfaces, which acts as a default gateway to their respective VLANs. Configuration : Here is a topology in which there is a router and a switch and some end hosts. 2 different VLANs have been created on the switch.
Router-on-a-stick (ROAS) is a technique to connect a router with a single physical link to a switch and perform IP routing between VLANs. From the switch's perspective, this physical link is configured as a trunk port allowing all VLANs that are going to be routed.
