Search results
8 cze 2024 · Ender-3 Pro, 2.0.8.2, Creality V4.2.2 2022-11-09. I tried to run the auto bed leveling (ABL) and noticed that the probe was functioning slightly differently to the how it behaved with the wrong (incorrect) firmware and was causing the nozzle to be pushed into the bed.
1.1 Pop-up error for leveling failure. 1.2 Build plate scratched by the nozzle. 1.3 Error occurred after only detecting a few points during the 16-point leveling process. 1.4 The nozzle keeps height-adjusting at the lower left corner, after repeating five times it returns to zero without proceeding with the 16-point leveling, Error Occurrence ...
You can easily tell if the leveling compensation is at least being used in the print by watching the z motor for movement on longer print sections. You can change the mesh to 6x6 in printer.cfg. Heat the bed to 60C for a few minutes, then run auto level. Increase your flow by 1%. What slicer?
25 lip 2022 · To fix your auto leveling sensors not working, first ensure that the sensor wires are properly connected to the right port. Your bed should be manually leveled to a good degree as well. Update your firmware to the correct version for your 3D printer and auto leveling sensor type.
With the nozzle at the proper height, adjust the Auto Bed Leveling sensor until that is the exact point it triggers and the LED light comes on. This can take a few minutes to get perfect, but only needs to be done once.
20 sie 2023 · I just received the Ender 3 v3 SE and The auto leveling flow fails all the time. The leveling starts, Nozzle heating/Cleaning are working fine, but the Auto Z Offset fails every single time.
12 maj 2021 · Despite starting with G28 & G29 in my G-code file, and the printer & BLTouch doing a proper bed levelling (the BLTouch seems to work as intended), the first layer comes out uneven. Please find some pictures below of a test print (this one).
