Search results
24 paź 2024 · Disable the DHCP server by adding option ignore '1' for the LAN interface in /etc/config/dhcp. To create a repeater, add a WDS access point along with the WDS station on the client (with the same ssid and key, or not). Do not forget to add the newly created AP to the LAN firewall Zone.
DD-WRT's repeater bridge mode tries to provide the same basic capability as WDS without requiring any special support from the remote AP. Essentially, it pretends to be a wireless client of the existing AP for every device connected to it, whether wired or wireless.
12 sie 2021 · 1) Go to Network > DHCP Server. 2) Deselect Enable DHCP Server and click Save. Now you can go to Advanced > Status > Wireless to check the WDS status. When the WDS status is Run, it means WDS bridging is successfully built.
2 paź 2024 · If you have radios/spectrum to spare the two WDS on different channels certainly is an easy method. If you're already talking sending data over two 5ghz links between two or four AP's. Perhaps a more elegant solution is using batman iv with vlans and going for a mesh topology.
21 kwi 2017 · 802.11 can carry the fourth, originator's MAC address, and this is used in WDS mode by repeaters. This feature can be enabled on Linux too, using iw, and enabling this mode will allow wlan0 to be used in bridge interfaces, as well as with VirtualBox bridged networking: iw dev wlan0 set 4addr on.
A wireless bridge may be the answer, either as a dedicated piece of hardware (like the Linksys WET54G) or using a spare wireless router with WDS capability as remote station. Both solutions get around the Linux driver issue in that no wireless driver is required.
2 sie 2013 · WDS can be used to provide two modes of wireless AP-to-AP connectivity: Wireless Bridging in which WDS APs communicate only with each other and don’t allow wireless clients or Stations (STA) to access them. Wireless Repeating in which APs communicate with each other and with wireless STAs. Updated 8/3/2013.
