Search results
14 lut 2020 · In this activity, you will configure trunk links between the switches. You will assign ports to VLANs and verify end-to-end connectivity between hosts in the same VLAN. You will configure trunk links between the switches, and you will configure VLAN 999 as the native VLAN.
DTP is normally used on Cisco IOS switches to negotiate if the interface should become an access port or trunk. By default, DTP is enabled, and the interfaces of your switches will be in “dynamic auto” or “dynamic desirable” mode.
Dostawca: Cisco. Tytuł: DTP – protokół dynamicznego trunkingu. Oprogramowanie: 12.X, 15.X. Platforma: Catalyst 2960, 3560, 3750, 3850, 4500, 6500. Zastrzeżony protokół DTP Cisco używany do automatycznego negocjowania tworzenia łącza Trunk między dwoma przełącznikami.
DSP Configurator Software. Extron offers a broad selection of easy-to-use configuration software applications used to configure, manage, control, and troubleshoot AV products and systems.
Following commands sets can be used to configure different Dynamic Trunking Protocol (DTP) modes for Switch interface. Refer folowing lessons if you are not familiar with Dynamic Trunking Protocol (DTP) .
How to configure dynamic trunking protocol (DTP) on Cisco switch? Cisco proprietary protocol used to automatically negotiate the formation of Trunk between.
To enable trunking from a Cisco switch to a device that does not support DTP, use the switchport mode trunk and switchport nonegotiate interface configuration mode commands. This causes the interface to become a trunk but not generate DTP frames.
