Search results
To convert pounds (lbs) to Newtons (N), multiply by 4.448 To convert inches (in) to millimeters (mm), multiply by 25.4. Note: When using Zinc Plated (lubricated with wax) Top Lock Nuts, the K value can vary be-tween 0.12-0.16. For additional technical information, contact Fastenal Engineering at engineer@fastenal.com.
13 cze 2023 · Conversion factors. The user should understand the conversion factors specific to each unit to convert torque from one unit to another. Here are the conversion factors for commonly encountered torque units: 1 ozf.in = 0.0625 lbf.in. 1 lbf.in = 16 ozf.in. 1 lbf.ft = 12 lbf.in.
STANDARD TORQUE VALUE CHART. There is no difference in the above chart between the torque figures for fine or coarse threads. The torque figures for a finely-threaded fastener as compared to a coarsely-threaded fastener of the same diameter may be slightly higher but hardly worth mentioning. CAUTION.
Torque Conversion Constants Table Chart. This is a x - y conversion constant table for torque.
TORQUE CONVERSION FORMULAE AND FACTORS. Accepted formulae relating torque and tension, based on many tests are...- FOR METRIC SIZES. x D. = 5000. = torque Nm. = bolt tension N. = bolt diameter (mm) FOR IMPERIAL SIZES. M = P x D. Torque. Force. Clamping force. Tension in bolt. Viljelijäntie 8, 00410 Helsinki +358 10 320 6400. www.haitor.com.
TORQUE COMPARISON TABLE. The below table should be used as a guideline for the correct torque to be applied to standard size metric and imperial bolts in grade 8.8 (metric) and ASTM A193 grade B7 (imperial) or similar.
Table 1: Torque correction factors for various threaded joint configurations. ..... 3 Table 2: Conversion factors for different torque units. ..... 6
