Search results
17 mar 2018 · If you're going to do a 3d printed one, just make sure the slot is as wide as a Carrera slot, and maybe even widen it a little through the turn. You might also be better off making it a squeeze hairpin with the slots just close enough to have room for the rails (copper tape), having the inside lane move up close to the outside lane.
25 lip 2021 · I’m in the process of modifying my current Carrera Digital 1/32 track layout (top) to the one below. I have sourced or bought all the necessary track pieces with the exception of two. One each 2/30 and 3/30 curve respectively of which I’ve circled.
Excerpt from "Sunday Races 062324"Come check it out at Road Trip 1300 S. Polk St., Suite 172 Dallas, TX 75224. I love this place. It is a blast. https://www...
You remove the standard Carrera guide blade and put the modified version in, allowing your Carrera cars to run on Scalextric track and pass over cross overs and turn through radius 1 turns without ANY issues.
Carrera track is very easy to assemble and disassemble so you can change your track layout frequently if you wish. Curves are available in radiuses one through four, with one providing the tightest turning radius for a 180° corner and radius four creating the largest turn.
13 cze 2002 · Buy Carrera 20020613 Hairpin Curve Slot Car Race Track: Race Tracks - Amazon.com FREE DELIVERY possible on eligible purchases.
26 lis 2019 · Here is my current layout of Prairie Winds Raceway. All four horizontal straights have been lengthened by one full straight since this drawing was made. The 180-degree R1 curve in the middle is a Carrera hairpin curve. I am considering changing to the layout below.
