Search results
The latest firmware, driver and setup software for your device can be downloaded from the Belkin Support site. Follow the steps below for details.Before you begin: Make sure that your computer has an active internet connection. Check the model number and hardware version of your device.
- Keeping Your Belkin Devices' Firmware Or Driver Updated
On the other hand, a driver is a type of software that lets...
- Keeping Your Belkin Devices' Firmware Or Driver Updated
Your cable or DSL modem must be equipped with an RJ45 Ethernet port. Many modems have both an RJ45 Ethernet port and a USB connection. If you have a modem with both Ethernet and USB, and are using the USB connection at this time, you will be instructed to use the RJ45 Ethernet port during the installation procedure. If your modem has only a USB ...
Modem Router, such as the USB software to allow you to print through the Modem Router’s USB port. If you wish to download and install any of these software programs, simply click on the button appropriate for your device.
The Hub provides four downstream USB ports that offer backward-compatible, Plug-and-Play connectivity with all USB devices, including USB 1.1 (or low- and full-speed) devices, as well as with USB 2.0 (or high-speed) devices.
By connecting to your network router, this innovative sharing tool gives you a great way to enhance its capabilities, as well as those of all the USB devices connected throughout your network. It lets you access your USB devices remotely without the hassle of setting up network software.
Connecting the Modem to your computer using the USB Port If your computer does not have an Ethernet port (a networking port) then you can connect the modem to your computer through an available USB port. Follow the directions below. 1. Insert the CD into your CD-ROM drive. The Belkin High Speed Cable Modem installer screen will appear.
Step 1: Connect the adapter to a USB-C port of a computer. NOTE: No additional drivers are needed. Step 2: Connect an ethernet cable to the adapter. Step 3: Connect the other end of the ethernet cable to modem, router, switch, or any RJ45 port. You should now have set up the Belkin F2CU040.
