Search results
The monitor detects your blood’s movement through the artery in your arm and converts the movements into a digital reading. The oscillometric method does not
MONITOR ARM ADJUSTMENT INSTRUCTIONS. Once your Monitor Arms are installed and your monitors are attached, it’s time to adjust the tension, tilt, and swing of your monitor arms for maximum comfort. Here’s a step-by-step guide for each adjustment.
Step 1: Choose a mounting option. You can mount the monitor arm using the: Desk-clamp mount to attach your monitor arm to the edge of a tabletop. Go to “Desk-clamp mount” on page 6. tabletop. This mounting option requires a hole through the mounting surface. Go to “Plate mount” on page 7.
• Place the cuff on your upper arm only. Do not place the cuff on other parts of the body. • The blood pressure monitor can only be operated with batteries. • To conserve the batteries, the blood pressure monitor switches off automatically if you do not press any buttons for 30 seconds.
Unless your physician recommends otherwise, use left arm to measure pressure. Do not talk during measurement. Do not cross legs and keep you feet flat on floor during measurement. Now you are ready. Follow these simple steps: 1. Sit comfortably with your left arm resting on a flat surface so that the center of your upper arm
Snap the cable manager off the lower section of the arm and place the monitor cables into the arm. Note: You must leave enough slack in your monitor cables for the monitor to rotate freely at the top of the arm and between the upper and lower arm. Failure to do so will limit the adjustability and movement of the monitor and may
The Arm Blood Pressure Monitor is intended to measure the systolic pressure and diastolic pressure, as well as the pulse rate of adult person via non-invasive oscillometric technique
