Search results
The lists below summarizes low carbon steel grade A36 mechanical properties such as modulus of elasticity (Young’s modulus), shear modulus, ultimate tensile strength, yield strength, Brinell hardness, etc.
- Us ASTM A36 vs European S235, Chinese Q235, Japanese Ss400 and Indian E250 Steel
The following tables show Q235 steel vs A36, SS400 E250 and...
- RSt 37-2, St 37-2
According to German standard DIN 17100, St37 steel is...
- Difference Between 304 vs 316 Stainless Steel Ss304 vs Ss316
Difference between 304 vs 316 stainless steel is that 304...
- AISI 1018
ASTM SAE AISI 1018 steel also called C1018 or1018 CRS (cold...
- S235JR Material
S235JR Steel (1.0038 Material) Mechanical Properties. The...
- Us ASTM A36 vs European S235, Chinese Q235, Japanese Ss400 and Indian E250 Steel
This page is mainly introduced the ASTM A36 Datasheet, including chemical information,mechanical properties, physical properties, mechanical properties, heat treatment, and Micro structure, etc.
A36 steel typically contains: Carbon: 0.25-0.29%. Copper: 0.20%. Manganese: 1.03%. Silicon: 0.28%. Sulfur: 0.05%. Phosphorus: 0.04%. A36 steel must meet specific mechanical property requirements set by ASTM, including a minimum yield strength of 36,000 psi and a tensile strength between 58,000 and 80,000 psi. Key Properties of A36 Steel
The most common low-carbon structural steel in the world, A36 Hot Roll Steel is strong, heavy, ductile, and cheap. It is exceptionally easily to weld and has good machinability properties. It is typically used for general structural purposes such as bridges and buildings.
30 maj 2020 · The graph bars on the material properties cards below compare ASTM A36 carbon steel to: wrought carbon or non-alloy steels (top), all iron alloys (middle), and the entire database (bottom). A full bar means this is the highest value in the relevant set.
Yield strength values for common steels are given below. Note 1 : Yield point 32 ksi [220 MPa] for plates over 8 in. [200 mm] in thickness. Note 2 : The maximum thickness of plates is limited to a maximum thickness of 2 in. [50 mm] for all grades. Note 3 : Ordinary strength.
The tensile strength of A36 steel is 58 ks and the yield strength is 36.3 KSI. The tensile and yield strength of 1018 steel is higher than A36 steel. The yield strength is 53.7 KSI and the tensile strength is 63 KSI.