Search results
Capacity Charts for Gas Pressure Regulators. The capacity of any regulator is not an absolute value, but will vary with the application depending on the prevailing differential. We hope the following charts will help you in your selection of a properly sized regulator.
ANSI Z21.80/CSA 6.22 is the standard for line pressure regulators, suitable for application in natural, manufactured, mixed gases, liquefied petroleum gases and LP gas-air mixture piping systems. Maxitrol, in compliance with ANSI Z21.80/CSA 6.22, offers line pressure regulators for 2 psi piping systems and piping systems up to 5 psi.
LP-GAS SERVICEMAN’S HANDBOOK The Emerson LP-Gas Serviceman’s Handbook serves as a general reference of information on LP-Gas and for the installation, operation and maintenance of LP-Gas equipment. It provides key data and answers important questions that are relevant to management and field servicemen in the LP-Gas industry.
The VS/HS storage tanks are designed for long-term storage of cryogenic liquefied gases under pressure in the range of 5 to 250 psig (.35 to 17.6 kg/cm2). Operation of the tank is fully automatic with the unit's regulator systems set to maintain preset pressure and flow conditions into a customer's pipeline.
Product Finder. Looking for a convenient natural gas regulator sizing calculator? Check out the BelGAS Regulator Sizing Wizard! Simply configure your regulator based on type, connection, and pilot operation, then size it according to pressure in, pressure out, and flow. Find the perfect regulator for your application hassle-free.
Integral Two-Stage: Combines a first stage pressure regulator and a second-stage regulator in a single unit. High Pressure: Reduces pressure from the container to a lower pressure in excess of 1 psi. Read the recommended product in the window below, along with other useful information.
Materials used to construct the pressure regulator need to be compatible with the intended gas service. All the wetted areas (parts of the regulator in contact with the gas) must be selected to avoid any reaction with the gas that could cause contamination in the gas stream or deterioration of the regulator components.
