Search results
This project assembles a 49:1 ferrite-core (“FT”) type #43 transformer that matches 50 ohm input to 2500 ohm end fed antenna. It is optimized for 3.5/7/10/14 MHz but will work reasonably well on all amateur bands from 80 meters thru 10 meters with a 135 foot length of wire and a short connection to ground.
An 80-10 end-fed half-wave antenna can be a very good performing part of an HF station. But its performance depends heavily on a well-designed and carefully constructed 49:1 unun, which matches the long wire impedance to within tuning range of operation. But the perfor-mance of an end-fed antenna is also very dependent on height above ground.
Recommended wire lengths and Installation Notes for Unun models 4932, 4935, 9130, 9132 & 9135. Table shows typical SWR relative to installed wire length. SWR will vary based on topography, proximity of nearby structures, configuration of the antenna wire and choice of ground or counterpoise.
Figure 2 shows the complete schematic view of a typical EFHW antenna system. Briefly, the 100pf/2kv cap across the primary of the impedance matching transformer is there to allow better tuning in the 10 meter band. The transformer is a step-up with an impedance ratio of 49:1, and wound on a type 43 toroid core.
20 lis 2020 · When using a 49:1 (better for higher bands) or 64:1 (better for lower bands) coupler, you have to cut the wire for resonance to lamda/2 minus velocity factor and end effect, e.g. about 20m long for the 40m band.
ratio (49:1, 56:1, 75:1 and 81:1) UNUN (UN-balanced to UN-balanced) transformers and antennas. The efficiency- Insertion loss of the transformers continues to be unmatched by any copycat or competitor products on the market.
4 sie 2020 · This is the page on the End-Fed Half-Wave antenna with a 49:1 transformer. This is a multiband antenna without the need for any tuner (which is the best type of antenna).
