Search results
I started the car and heated up with choke but still stalling. I replaced the spark plugs and nothing. And i cant tune the carburetor because when i step off the gas pedal, the car is stall.
- my car keeps stalling?
Try tuning your carburetor. To do so, take your screw driver...
- Satsuma keeps stalling
Satsuma stalls when put in 1st or reverse gear. Im using...
- my car keeps stalling?
This is the troubleshooting page for Satsuma; it contains solutions to the most common issues about the subject. Use the article comments at the end of the page for sharing any issues that are not currently present here. The following issues might arise during the building process of the car...
8 lis 2016 · Try tuning your carburetor. To do so, take your screw driver and look for a screw at the base of your carburetor. Turn the screw until your RPM sits around 1000. This should fix your stalling problem. Good luck!
30 lis 2022 · Satsuma stalls when put in 1st or reverse gear. Im using autoclutch and driving with a keyboard. to drive i need to rev it to red and then change gears. In MSCE everything is bolted, fine tuned, everythings good. but it keeps stalling https://www.youtube.com/watch?v=i64jV1aI0vY.
When the car is on the neutral RPM could even reach max, but when I switched to 1st gear, all the RPM went down, car stalled some time later, and red LED turned on. After this, I switched all the pistons and spark plugs, re-builded the gearbox and still nothing.
So yeah as it turns out this problem can most likley be solved with 100MK and some spark plugs so check those before you do as i did and go above and beyond ...
So there are a few issues I see here: First of all your AFR is EXTREMELY off. Now as for the stalling, to me that could be a lot of things ranging from the AFR being wrong to your clutch being broken. I've also heard that the crankshaft being broken can cause this.
