Search results
20 sty 2019 · Browse to 192.168.1.254 to get to the admin settings for the 2wire box. Go to Settings | System Info | Event Notifications and check enable detection of router behind router conditions . This setting is not on by default!
Make sure your 2Wire or Pace gateway and computer are connected by an Ethernet cable, and the connection is secure on both ends. Log in to your gateway on the connected computer.
The tool shows the IP address, subnet mask and gateway of your PC at the top left. Subnet mask (eg 255.255.255.0) and gateway (eg 192.168.0.1) can be taken over, for the DNS address you can take 8.8.8.8.
31 gru 2012 · Get into your U-verse router, usually by going to 192.168.1.254 Log in (password will be on your router) From the home screen, Click on SETTINGS>FIREWALL tab>Pinholes and DMZ
2Wire and Pace gateways support both dynamic and static IP addressing on your internal network. The gateway's DHCP server automatically assigns an IP address to a network device upon request. You can also manually configure a static IP address for any device on your network.
20 gru 2002 · help with setup 2wire 2701hg-g as bridge mode, and use static IP Sonic legacyDSL>FTTN switch; IPv4's up, but no IPv6 of any kind (6rd / 6in4) dsl consistently disconnecting 2701HG-B Gateway.
10 wrz 2008 · I can access both the 2Wire 1800HG Gateway and the LinkSys WRT350N Wireless Router easily from any computer on the 192.168.2.0 network. Computers on the 192.168.2.0 network can see...
