Search results
4 gru 2022 · I installed the driver that Yaesu offers, name PL23XX_Prolific_DriverInstaller_v402, and I'm plugging it to a USB port in my computer using the cable that came with the Yaesu FT5D and then I get this error:
21 lis 2023 · WSJT-X complains that there is an error in his audio input device. I logged in to his PC, verified his settings, and tried everything I could think of but my luck wasn't any better than his. I figured I'd start by posting here to see if anyone else has had this same problem.
13 maj 2019 · Using Ham Radio Deluxe for CAT (configured as FT991A), and using the internal sound card via the Yaesu drivers. I had CAT working fine, and WSJT-X was receiving fine, and putting the radio into transmit, but no signal transmitting.
27 lip 2023 · In 2021, I acquired a Yaesu FTM-300 and connected it to my Dell Latitude 3520 laptop (Windows 10) running WIRES-X. Everything ran fine. As time went by, I started getting the "Transceiver Not Connected" message on the lower left screen. Rebooting the laptop would usually fix the problem.
20 cze 2023 · The issue is the drivers that are assigned to the HRI-200 vs the actually and correct drivers. You will need to manually install the correct driver for the device as compared to deleting it. If you just delete it the chances of the wrong driver being selected again is possible.
26 lis 2018 · Once the wrong driver is installed it can be very difficult to uninstall. The correct driver can be downloaded from the radio manufacture’s website. Once the driver is properly installed and the radio connected the driver can be found in the Windows Device Manager as shown in Figure 1.
30 kwi 2023 · The error was just “Error” in a box with no other information. The computer can see the files the radio wrote to the card. I’m going to try formatting the card right now and I’ll post the results in a few minutes.
