Search results
A splice is a way of terminating a rope or joining two ends of rope together without using a knot. Apart from being bulky and unsightly, even a correctly tied knot can cause significant loss of strength to a rope.
The following information refers to a splice made in a 10 mm rope. For other rope diameters, adapt the dimensional specifications accordingly. Form the rope end into a tip and wind adhesive tape around it.
Samson Tubular, Wire or Selma fids are available in a variety of sizes depending on the rope type and diameter you’re splicing. PUSHER Helpful for extracting cores or pushing a fid through the rope. TAPE Masking tape, electrical tape or a similar plastic tape can be used during splicing. SCISSORS OR KNIFE For cutting away strands — must be ...
In order to splice, you’ll need a pair of rope ends, patience and the right tools! These will vary according to the type of rope being spliced. The splicing fid is a traditional tool to make openings beneath the strands of twisted or square plaited ropes. Braided ropes are spliced using a fid and pusher.
Select the appropriate ferrule according to our splicing table. Wire rope constructions with a metallic cross-sectional area factor of less than 0,283 should not be used. These splicing instructions work for wire rope constructions according to EN 12385-4. Wire rope constructions with a tensile grade above 1960 N/mm 2 should not be used. 2.
24 wrz 2019 · Eyes, or loops, can be created at one end of a length of wire rope by using a mechanical splice with a swaged sleeve, a hand-tucked splice, or wire rope clips. Fittings can be secured to wire rope by swaging, by pouring molten zinc or a resin that bonds to the wires, or by using a wedging arrangement.
We provide recommended splices for all sliceable Yale ropes and tools. The strengths shown in our catalogs and on this site are for spliced lengths. Other terminations can be used, but their strength loss with a particular type of rope and construction should be determined and not assumed.
