Search results
IT IS VERY IMPORTANT THAT THOSE RESPONSIBLE FOR THE INSTALLATION OF THIS EQUIPMENT, AS WELL AS THE OWNER/OPERATOR, READ THIS MANUAL AND CAREFULLY FOLLOW THE INSTRUCTIONS AND GUIDELINES. Table of Contents.
Water pressure (psi):_____ Water flow rate (gpm):_____ 5 Select a location that meets the following guidelines. x The unit must be installed between the cold water source and the water heater as inlet temperature must not exceed 100oF. (See Figure 1 for proper installation sequence.) x The disinfection unit can be installed either horizontally ...
Compact, rugged and reliable, the 100 is a positive displacement pump for flooded inlet, low volume, and low-pressure applications. Perfect where a low volume fill pump is needed, the unique wobbler design has no valves, and can pump a wide range of chemicals and fluids.
EZ-POUR® Premium Viton® Replacement Spout Gaskets and Retainer Rings. $ 4.98 – $ 10.49. Part #G1. Gaskets fit all of our spout models, made out of Viton rubber. Contains gaskets and retainer rings. $4.98 pkg of 2, $6.99 pkg of 5, $10.49 pkg of 10.
Designed and built for high flow, low noise, smooth flow with no rapid cycling and SHURFLO reliability, this fresh water demand pump is quiet and can run dry without damage. Mounts in any position. This pump is designed to replace both the 4900 and 5900 Smart Sensor series products.
(1) Fill the suction line with water and connect it to the suction inlet. (2) Remove the priming plug and fill the pump body with water. (3) Screw the plug to the priming inlet. (4) Turn the power on. The pump should deliver water to the plumbing line within 30 seconds. If not, unplug the pump and repeat the process at step 2.
️ [ HIGH PERFORMANCE ]: This 12V diaphragm pump offers a powerful 1.3 GPM water flow and 100 PSI shut-off pressure, delivering reliable and consistent water pressure for all your on-demand applications in marine, RV, agriculture, and off-grid environments.
