Search results
Follow these steps to get your Smart Oil Gauge connected: Start by checking that the batteries are seated properly. Slide open the battery box, take the batteries out, put them back in, and turn the device back on. You should briefly see a red light illuminate deep down inside of the device.
Tip: Always connect the Smart Oil Gauge to WiFi BEFORE installing on the oil tank. Instructions to connect to WiFi can be found on the QuickStart Guide in the box, or here: QuickStart Guide. If you run into trouble configuring your Smart Oil Gauge, please refer to our Troubleshooting Guide here.
Follow these to set up the device on your WiFi network. Do this at the kitchen table. – Installer/Technician Instructions. These are for installing the gauge in your oil tank. Note: Installation should be done by qualified, licensed, and insured persons only.
QuickStart Guide. To setup your Smart Oil Gauge, simply follow the steps in the QuickStart Guide below. This will allow you to connect the device to your home’s WiFi network. In the final step, the device will send you an e-mail that you will use to create your account (username and password).
29 lip 2024 · The installation process is a little bit different depending on your tank’s orientation, especially between Granby and Roth tanks. In this blog post, I’ll be covering the process of installation for your Smart Oil Gauge! What You’ll Need. When it comes to installing the Smart Oil Gauge, you don’t need much.
13 maj 2024 · In this blog post, I’ll cover all the ways you can make sure that your gauge is set up properly! The Smart Configuration Method. The first method that you’ll likely try is the “Smart Config” method. You can find this method by going onto the Smart Oil Gauge App and clicking on “connect sensor”.
The Smart Oil Gauge uses an ultrasonic sensor to measure the level of oil in the tank throughout the day, and transmits this information over your home’s Wi-Fi network.
