Search results
Enable "Settings (administrator)" - [System Settings] → [Image Send Settings] → [Fax Settings] → [Condition Settings] → [Fax Dest. Confirmation Mode]. When this setting is enabled, an address confirmation message will appear when you send a fax to prevent erroneous transmission.
Did a communication error occur? If an error occurs that prevents transmission, the transmission is temporarily canceled and then automatically re-attempted after a brief interval. (Factory default setting: 2 attempts, 3 min. intervals)
First 2 digits of communication error number: Error code from 00 to 99. Last 4 digits of communication error number: Code for use by service technicians. A fax was sent from a party from which reception is blocked.
Jeśli mimo to wykryta zostanie wada lub wystąpi inny problem, skontaktuj się ze sprzedawcą lub najbliższym autoryzowanym punktem serwisowym.
The transaction failed due to a communication error. First 2 digits of communication error number: Error code from 00 to 99. Last 4 digits of communication error number: Code for use by service technicians. Reject Reception: A fax was sent from a party that has been blocked by the anti junk fax function.
The machine supports error correction mode (ECM) and is configured to Fax Problems original size is still not detected correctly, specify the original size manually. Perform the transmission again.
The machine supports error correction mode (ECM) and is configured to automatically resend any [System Settings] → [Image Send Settings] → [Fax Settings] → [Default Settings] → [ECM] Divide the originals into sets and fax each
